Technical Articles

Design notes on power protection, regulation and battery management, written by the engineers who build the modules.

Why Your Battery-Powered Device Flickers Off Before It’s Actually Dead

Have you ever noticed a battery-powered device turn off, turn back on, then turn off again as its battery gets low? It’s a typical behavior of low-cost battery-powered devices, and it isn’t a fault in the device itself. It’s the battery protection circuit reacting to something called cell polarization.

By Nick Kowalski

Power abstraction layer: a software interface for your power system

A software contract for shared power rails, readiness feedback and fault recovery, built around the controls the hardware actually provides.

What Is a PSOM (Power System On Module)?

To meet the challenge of designing complete power systems, many robotics and embedded teams are starting to look for an integrated alternative to chip-level power design. The motivation is the same one that moved designers from custom processor boards to compute SOMs: time to market, reliability, and the simple fact that power is rarely the […]

By Ethan Johnston

How using a TP4056 Battery Charger can Ruin Your Project

A TP4056 module charges a cell. It does not manage one. What the parts on the board actually do, where builders assume protection that is not there, and what a lithium project needs instead.

By Nick Kowalski

Over-Current Protection Circuits that are Better than Fuses

A fuse melts late, imprecisely, and only once. Six over-current topologies that do better, from a PTC to a solid-state breaker, and what each one costs you.

By Nick Kowalski

Continuous Over-Voltage Protection Circuits

Continuous over-voltage is a common way circuits get destroyed because fuses and transient over-voltage protection devices like MOVs, TVS diodes and GDTs are not well suited to protect against them. In this article, we will discuss the pros and cons of different circuit topologies that are specifically for continuous over-voltage protection. Voltage Protection Topologies Over-voltage […]

By Nick Kowalski

Why Overvoltage Protection Is Critical for Your Circuit (and 3 Ways to Add It)

Every electronics engineer eventually learns this lesson the hard way: you plug in power, a faint (or extremely loud) “pop” echoes through the room, and the circuit dies instantly. That’s the story of overvoltage. It is when the voltage applied to your circuit exceeds what your components can safely handle. Whether it’s from a mis-wired […]

By Ethan Johnston